TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 387
System board and components
Ê If applicable, reinstall the rear fan as described in section "Installing the rear
fan" on page 189.
Ê "Installing the system fan holder" on page 77
Ê "Reassembling" on page 64
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê "Connecting the server to the mains" on page 74
Ê "Updating or recovering the system board BIOS and iRMC" on page 87
Ê Reconnect all external cables.
Ê "Switching on the server" on page 75
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section "Verifying system
information backup / restore" on page 89.
Ê "Verifying the system time settings" on page 96
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 101.
Ê After replacing the system board in a server running Linux OS, update the
MAC address of the onboard network controller in the related NIC definition
file as described in section "Updating the NIC configuration file in a Linux
environment" on page 99.
Ê "Enabling SVOM boot watchdog functionality" on page 94
Ê "Enabling BitLocker functionality" on page 100
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 376.
Ê If applicable,"After replacing the system board" on page 104
To Next Page
Loading...
Need help?
General