Check of front disc brakes
P-15
Brake disc removal essentials
Prior to the removal, mark on the hub bolt and brake
disc for reference at the installation time.
Essentials to the Installation of Brake Disc
1. Clean up any rust or grime on the contact
surface of brake disc and hub.
2. Align with the mark made prior to the removal
and fit up the brake disc.
Essentials to the Installation of
Internal/External Friction Plate
1. Push out, with the SST, the piston to the end.
2. Install the brake pad.
Replacement of the Internal and External
Friction Plate
1. Disassemble in the order as shown in the Table.
2. Assemble in the reversing order of disassembly
1 Guide pin cover
2 Guide pin
3 Internal/external friction plate
4 rear brake caliper
5 Guide pin sleeve
Mark
Wood plate
To Next Page
Loading...