Steering system
N-12
Installation of steering and joint
1. Install in the order shown in the Table.
1
Dust cover of steering tie rod ball
·Refer to the Installation Instructions
2
Rubber cushion block:
Refer to the Installation Instructions
3 Steering casing
4 Bracket
5 Gear rack
6 Oil seal: Refer to the Installation Instructions
7 Piston
8 Rack bushings assembly
9 “O” ring
10 Rack block
11 Snap ring
12 “O” ring
13 Valve casing
14 Oil seal
15
Upper bearing: Refer to the Installation
instructions
16 Pinion shaft
17
Seal ring: Refer to the Installation
instructions
18 Control valve
19 Spring snap ring
20 Lock bolt
21 Briquetting plug
22 Spring
23
adjusting cap:
Refer to the Installation Instructions
24
Lock nut(adjusting cap): Refer to the
Installation Instructions
25 Inside tie rod assembly
26 Dust cover
27 Clamp
28 Small clip
29 Tie rod lock nut
30 Outside tie rod assembly
31 Intake oil pipe
32 Oil pipes 1 and 2
To Next Page
Loading...