Steering system
N-13
Installation instructions of steering tie rod
ball dust cover
1. Wipe out greasy dirt on the ball joint;
2. Add a few grease in the new dust cover.
3. Use a special tool and a presser to fit up the
dust cover onto the tie rod end ball.
4. Wipe out all exposed grease.
Installation instructions of rubber cushion
block
1. Smear soapsuds on the rubber part of rubber
pad.
2. Use a special tool and a presser to press the
rubber spacer block until then end of rubber
comes out of the casing.
3. Turn over the casing, press the rubber spacer
block until it comes out of another end.
4. The rubber spacer block shall be aligned with
the steel tube.
Installation instructions of upper bearing
1. Smear suitable amount of grease on the new
upper bearing.
2. Use a special tool to press in the bearing.
Installation instructions of seal ring
1. Use a special tool to fit up a new seal ring on
the valve body of gear shaft.
2. After installation, use a special tool to put the
seal ring in place.
3. Fit up the snap ring
Installation instructions of adjusting cap
1. Place the gear rack in the middle place.
2. Tighten the adjusting cap, enabling its
tightening torque to reach to 19.6N.m
{2.0kgf.m,14.5ft.1bf} for three times, and then
use a special tool to turn the end cap for 23°.
3. Smear a layer of sealant on the threads of lock
nut.
4. Connect the lock nut
5. Use a special tool and a spring balance to
measure the torque of adjusting rod.
● If non-conform to the standard, repeat the steps
2-5.
To Next Page
Loading...