HAIMA 7 - Page 493

Wiper and washer
T-29
Check Display State Measures
Wait for 2s after the
DTC 20 chosen.
Put through and cut off the rear
windshield defroster relay for
three times.
The rear windshield defroster
relay is normal.
Other than the above cases. Measure the voltage of
combination instrument terminal
3P.
Is the voltage equal to B+？
l If this value is satisfied,
replace the combination
instrument.
l If this value is unsatisfied,
Check the following parts.
— Harness (combination
instrument—rear
defroster relay)
DTC 21 Signal to the door lock timer
Combination instrument connectors
Harness side connector
(Viewed from the harness side)
XMET18W017
Check Display State Measures
Wait for 2s after the
DTC 21 chosen.
Turn on/off all door lock buttons
for three times.
The door lock timer is normal.
Other than the above cases. Measure the voltage of
combination instrument terminal
3D.
Is the voltage equal to B+？
l If this value is satisfied,
replace the combination
instrument.
l If this value is unsatisfied,
check the following parts.
— Door lock timer;
— Harness
(Battery.— door lock
timer— combination
instrument)
(Flashing)
(Flashing)