HAIMA 7 - Page 494

Alarm and Indication System
T-30
DTC 22 Fuel level signal
Combination instrument connectors
Harness side connector
(Viewed from the harness side)
XMET18W017
Steps Check Display Measures
1 Disconnect the connector of
fuel gauge sensor and choose
DTC 22.
Go to the next step.
Other than the
above-said display.
Replace the combination instrument.
2
Connect the combination
instrument terminal 3C with
the grounding.
Go to the next step.
Other than the
above-said display.
Replace the combination instrument.
3
Use the special tool (fuel and
temperature tester) or
resistance to input the
resistance 20Ω to the
combination instrument
terminal 3C.
Go to the next step.
Other than the
above-said display.
Replace the combination instrument.
4
Use the special tool (fuel and
temperature tester) or the
resistance to input the
resistance 60Ω into the
combination instrument
terminal 3C.
Go to the next step.
Other than the
above-said display.
Replace the combination instrument.
5
Use the special tool (fuel and
temperature tester) or the
resistance to input the
resistance 100Ω into the
combination instrument
terminal 3C.
Go to the next step.
Other than the
above-said display.
Replace the combination instrument.