HAIMA 7 - Page 497

Wiper and washer
T-33
Check Display State Measures
1. Set the indoor
light switch in
the DOOR
position.
2. Wait for 2s after
the DTC 27
chosen.
The indoor light is on and off for
three times.
The indoor light is normal.
Other than the above cases. Measure the voltage of
combination instrument terminal
1H.
Is the voltage equal to B+？
l If this value is satisfied,
replace the combination
instrument.
l If this value is unsatisfied,
check the following parts.
— Indoor light
— Harness
(battery-indoor
light—combination
instrument)
DTC 29 Rear fog lamp signal On/Off
Combination instrument connectors
Harness side connector
(Viewed from the harness side)
Steps Check Display Measures
1
1. Confirm that the rear
fog lamp indicator
light is not lit.
2. Press the switch of
rear fog lamp (rear fog
lamp switch is On)
Go to the next step.
Measure the voltage of combination
instrument terminal 3T.
Is the voltage equal to 5V？
l If this value is satisfied, replace the
combination instrument.
l If this value is unsatisfied, check the
following parts.
— Rear fog lamp switch
— Harness (combination
instrument—rear fog lamp
switch)
(Flashing)