HAIMA 7 - Page 499

Wiper and washer
T-35
Steps Check Display Measures
2
Pull out the ignition switch
from the steering lock.
(Key-reminder switch Off).
Measure the voltage of combination
instrument terminal 2J.
Is the voltage equal to 0V？
l If this value is satisfied, replace the
combination instrument.
l If this value is unsatisfied, check the
following parts.
— Key-reminder switch
— Harness (battery—key- reminder
switch—combination
instrument).
The signal input of combination
instrument is normal.
DTC 40 Front fog lamp relay signal On/Off
Combination instrument connectors
Harness side connector
(Viewed from the harness side)
XMET18W18
Steps Check Display Measures
1
Turn on the switch of front
fog lamp (Front fog lamp
relay On)
Go to the next step..
Measure the voltage of combination
instrument terminal 2N.
Is the voltage equal to B+
l If this value is satisfied, replace the
combination instrument.
l If this value is unsatisfied, check the
following parts.
— Front fog lamp switch
— Harness (combination
instrument—front fog lamp
relay)