Wiper and washer
T-37
Steps Check Display Measures
2
Set the shift lever in the
shift position P
Measure the voltage of combination
instrument terminal 4B.
Is the voltage equal to 5V？
l If this value is satisfied, replace the
combination instrument.
l If this value is unsatisfied, check the
following parts.
— Shift switch P
— Harness (ignition switch—shift
lock solenoid valve (signal in the
position P)—combination
instrument)
The signal input of combination
instrument is normal.
DTC 42 Working signal to the solenoid valve of key interlock.
Combination instrument connectors
Harness side connector
(Viewed from the harness side)
XMET18W16
Check Display State Measures
Wait for 2s after the
DTC 42 chosen.
Turn on/off the solenoid valve of
key interlock for three times.
The solenoid valve of key
interlock is normal.
Other than the above cases. Measure the voltage of
combination instrument terminal
1G.
Is the voltage equal to B+？
l If this value is satisfied,
replace the combination
instrument.
l If this value is unsatisfied,
check the following parts.
— Indoor light
— Harness (combination
instrument—solenoid
valve of key interlock)
(Flashing)
To Next Page
Loading...