HP DesignJet Z2100

Designjet Z Series — Service Manual 3-17
Service Tests (Diagnostics)
 Starting Horsburgh and Mips.
 Starting Nvm.
 Starting TestsGPIO.
 Starting Nvm Motor
 Getting Part Number.
 Starting SvsMotor.
 Starting CarriageMotor.
 Starting ServiceStation.
 Moving SVS to rear bump.
 Homing Scan Axis.
 Move Carriage out of SVS path.
 Homing Service Station.
 Starting ServicingServices.
 Capping Service Station.
 Uncapping Service Station.
 Starting Cutter.
 Starting PaperMotor.
 Starting Media Sensor.
 Reading Media Presence.
5 If paper is already loaded, the printer detects the paper and continues the
test. If paper is NOT loaded, the Front Panel prompts you to load roll media.
6 Raise the Media Lever, load roll media, lower the Media Lever, and press
any key to continue.
7 The printer then starts an actual test cut of the media. As the test executes the
Front Panel displays the following messages:
 Advance paper.
 Engaging cutter.
 Cutting paper.
 Disengaging cutter.
8 Once the test has completed the Front Panel displays the test result and
prompts you to confirm that the cutter worked.