Designjet Z Series — Service Manual 6-167
Removal and Installation - Starwheel Assembly
4. Carefully lift the Starwheel Assembly and
move it into the space to the left so you can
remove it from the printer in the next step.
5. Carefully remove the Starwheel Assembly
from the printer to the right.
Installation
1. Carefully remove the Starwheel Assembly
from the packaging.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
Refer to page 6-8,
Service Calibration Guide to Removal and Installation
.
The Starwheel Assembly with Actuator is only used for Z2100/Z3100 printers
(except Z2100 Revision C).
To Next Page
Loading...