6-186 Designjet Z Series — Service Manual
Removal and Installation
Media Advance Roller
Removal
1. Remove the Left Cover (refer to page 6-30).
2. Remove the Clean Out Assembly (refer to
page 6-78).
3. Remove the Electronics Module (Main PCA
and PSU) (refer to page 6-163).
4. Remove the Left Spittoon (refer to page 6-
175 ) .
5. Remove the Media Advance Drive (refer to
page 6-181).
6. Remove the Media Advance Roller drive
gear wheel to gain access the locking
plate attachment screw.
7. Remove two T-15 screws that secure the
Media Advance Roller locking plate to the
printer.
Switch off the printer and remove the power cable.
The Media Advance Roller
drive gear is is delicate, and
should be removed straight off
the spindle.
To Next Page
Loading...