Designjet Z Series — Service Manual 6-181
Removal and Installation - Media Advance Drive
Media Advance Drive
Removal
1. Remove the Left Cover (refer to page 6-30).
2. Remove the Electronics Module (Main PCA
and PSU) (refer to page 6-163).
3. Remove the Left Spittoon (refer to page 6-
175 ) .
4. Remove the Encoder Disk and Encoder
Sensor (refer to page 6-178).
5. Unroute the Media Advance Drive power
cable.
6. Remove three T-15 screws that secure the
Media Advance Drive to the printer.
Switch off the printer and remove the power cable.
To Next Page
Loading...