Designjet Z Series — Service Manual 6-71
Removal and Installation - PrintMech PCA
PrintMech PCA
Removal
1. Remove the Right Cover (refer to page 6-
27).
2. Disconnect all the electrical connectors
from the PrintMech PCA.
3. Remove the grounding cable attachment
screw from the PrintMech PCA.
Do NOT remove and install both the PrintMech PCA and the Formatter at the
same time.
If you have previously removed and installed the Formatter, make sure that
you complete the procedure and the instructions provided on the flyer that
accompanies the Formatter. Refer to Page
6-159
before installing the
PrintMech PCA.
Switch off the printer and remove the power cable.
To Next Page
Loading...