6-122 Designjet Z Series — Service Manual
Removal and Installation
Color Sensor ESP (spectrophotometer)
Removal
1. Remove the Right Cover (refer to page 6-
27).
2. Remove the Left Cover (refer to page 6-30).
3. Remove the Front Panel (refer to page 6-
48).
4. Remove the Top Cover (refer to page 6-51).
5. Remove the Window Position Sensor (refer
to page 6-54).
6. Remove the Ink Supply Tubes Support Rail
(refer to page 6-56).
7. Open the Carriage Cover.
The illustration shows the Z2100 which only
has four Printheads, for the Z3100 there
are six Printheads.
8. Remove all the Printheads.
Switch off the printer and remove the power cable.
To Next Page
Loading...