Designjet Z Series — Service Manual 1-67
Ink Supplies Troubleshooting
4 If the loaded paper is satisfactory, the printer will run the realignment and
print a realignment pattern. Ensure the transparent window is closed, as a
strong light source near the printer during printhead realignment can affect
alignment.
Z3100/Z3100ps/Z3200ps Plot:
Z2100 Plot:
5 The process will take about five minutes. Wait until the front panel display
shows the process complete before using the printer.
Scanning errors during alignment
If the alignment process FAILs, a scanning problems message appears on
the front panel. This means that the alignment has not completed
successfully. Therefore the printer is not aligned and the alignment should be
repeated before printing with good image quality. The problem may be due
to:
The paper used was not valid, repeat the alignment with valid paper.
To Next Page
Loading...