6-82 Designjet Z Series — Service Manual
Removal and Installation
Left Roll Guide
Removal
1. Remove the Spindle (refer to page 6-75).
2. Remove the Clean Out Assembly (refer to
page 6-78).
3. Remove five T-15 screws that secure Left Roll
Guide to the printer.
4. Lower the left end and remove the Left Roll
Guide from the printer.
Switch off the printer and remove the power cable.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
Refer to page 6-8,
Service Calibration Guide to Removal and Installation
.
To Next Page
Loading...