6-56 Designjet Z Series — Service Manual
Removal and Installation
Ink Supply Tubes Support Rail
Removal
1. Remove the Right Cover (refer to page 6-
27).
2. Remove the Left Cover (refer to page 6-30).
3. Remove the Front Panel (refer to page 6-
48).
4. Remove the Top Cover (refer to page 6-51).
5. Remove the Window Position Sensor (refer
to page 6-54).
6. Remove the Ink Supply Tubes from the Ink
Supply Tubes Support Rail.
7. Remove the T-15 screws that secure the rear
attachment brackets to the Ink Supply
Tubes Support Rail.
Switch off the printer and remove the power cable.
To Next Page
Loading...