Designjet Z Series — Service Manual 1-5
General Troubleshooting
Performing the Necessary Service Calibrations
Is the printer calibrated correctly after replacing a component? For
information on the Service Calibrations and how to use them,
see Service
Calibration Guide to Removal and Installation, Page 6-8 and Chapter 4,
Service Calibrations.
The Printer does not Power ON
1 Check that the power cord is connected correctly to the Printer and to the
Power Socket.
2 Check that the Power Switch on the BACK of the Printer is in the ON
position.
3 Check to see the LED on the Front Panel Power Switch are On.
4 Check that the Front-Panel Cable is correctly connected to the Electronics
Module. Also make sure that the Front-Panel cable is not damaged.
5 Replace the Power Supply Unit Page 6-166.
What to do if the Front Panel is blank or system
error 08:YZ is displayed
The LEDs of the formatter (only present on Z2100 RevD and Z3200 RevB are
visible through the cover) and the power supply can help you troubleshoot a
problem when the Front Panel is blank.
1 The following image shows the Power Supply LED, looking through the cover.
Remember that certain Calibrations are required even if an
Assembly has been disassembled to gain access to another
Assembly or Component.
To Next Page
Loading...