6-212 Designjet Z Series — Service Manual
Removal and Installation
Starwheel Motor
Removal
1. Remove the Front Cover (refer to page 6-
17 ) .
2. Remove the Left Cover (refer to page 6-30).
3. Remove the Electronics Module (Main PCA
and PSU) (refer to page 6-163).
4. Remove the Left Spittoon (refer to page 6-
175 ) .
5. Disconnect the Starwheel Motor electrical
connector.
6. Carefully pull the two gear wheels off their
shafts to gain access to the Starwheel
Motor attachment screws.
Switch off the printer and remove the power cable.
To Next Page
Loading...