Designjet Z Series — Service Manual 6-159
Removal and Installation - Formatter
Formatter
Removal
1. Fully loosen the two locking thumbscrews
that secure the Formatter in the printer.
1. Begin lifting the Formatter from the printer.
Push the clips and provide upward force at
the same time.
Do NOT remove and install both the PrintMech PCA and the Formatter at the
same time.
If you have previously removed and installed the PrintMech PCA, make sure
that you complete the procedure and perform the necessary Service
Calibrations. Refer to Page
6-71
to make sure you have completed the
procedure, and Refer to Page 6-8,
Service Calibration Guide to Removal and
Installation
, to check what Service Calibrations you should perform.
Switch off the printer and remove the power cable.
To Next Page
Loading...