HP DesignJet Z2100

Designjet Z Series — Service Manual 6-19
Removal and Installation - Right Front Trim
Right Front Trim
Removal
1. Remove the Front Cover (refer to page 6-
17 ) .
2. Remove the Media Output Assembly (refer
to page 6-18).
3. Remove two T-15 screws that secure the
Right Front Trim to the printer.
4. Open the Right Ink Cartridge Door.
5. Unclip the Right Front Trim.
Switch off the printer and remove the power cable.
On some printers, the Right Front
Trim is integrated with the Output
Support. In this case, you need to
remove three screws that secure
the Right Front Trim to the printer
(shown in the small graphic on the
left). Once you have removed the
three screws, you are free to
remove the Right Front Trim from
the printer.