Designjet Z Series — Service Manual 6-51
Removal and Installation - Top Cover
Top Cover
Removal
1. Remove the Window (refer to page 6-13).
2. Remove the Right Cover (refer to page 6-
27).
3. Remove the Left Cover (refer to page 6-30).
4. Remove the Rear Tray (refer to page 6-36).
5. Remove the Rear Cover (refer to page 6-
37).
6. Remove the Front Panel (refer to page 6-
48).
7. Remove the four T-15 top screws that secure
the Top Cover to the printer.
8. Remove the front T-15 screw that secures the
front left side of the Top Cover to the
printer.
Switch off the printer and remove the power cable.
To Next Page
Loading...