HP DesignJet Z2100

Designjet Z Series — Service Manual 6-1
6
Removal and Installation 5
Introduction 6-2
Service Calibration Guide to Removal and Installation 6-8
Window 6-13
Covers and Trims 5-17
Rear Tray 6-36
Rear Cover 6-37
Media Lever 6-38
Media Lever Position Sensor 6-41
Cutter Assembly 6-43
Left Rear Tray Support 6-46
Front Panel 6-48
Top Cover 6-51
Window Position Sensor 6-54
Ink Supply Tubes Support Rail 6-56
Service Station 6-60
Drop Detector 6-64
Aerosol Fan Assembly 6-65
Primer Assembly 6-67
PrintMech PCA 6-71
Pen to Paper Space (PPS) Solenoid 6-73
Spindle 6-75
Left Spindle Holder 6-76
Right Spindle Holder 6-77
Clean Out Assembly 6-78
Out Of Paper Sensor 6-79
Left Roll Guide 6-82
Right Roll Guide 6-83
Encoder Strip (with spring and attachment nut) 6-84
Clean Encoder Strip Procedure 6-86
Trailing Cable (with Carriage PCA Cover) 6-92
Carriage Assembly and Trailing Cable 6-100
Extra High PRS Wedge 6-109
Carriage Rear Bushing 6-113
Belt Assembly 6-115
Scan-Axis Motor 6-116
Carriage Rail Oiler 6-120
Color Sensor ESP (spectrophotometer) 6-122
Line Sensor 6-128
Carriage Cover (includes Carriage Latch) 6-133
Carriage PCA 6-138
Right Ink Supply Station 6-143
Left Ink Supply Station 6-147
Ink Supply Tubes 6-151
Formatter 6-159
Hard Disk Drive 6-161
Electronics Module (Main PCA and PSU) 6-163
Starwheel Assembly 6-166
Print Zone Overdrive 6-171
Left Spittoon 6-175
Encoder Disk and Encoder Sensor 6-178
Media Advance Drive 6-181
Media Advance Roller 6-186
Pinchwheel Assembly 6-192
Pinch Roller 6-200
Rubber Pinchwheel Kit 6-201
Left Starwheel Lifter 6-205
Right Starwheel Lifter 6-208
Starwheel Motor 6-212
Full Bleed Foam 6-214