Designjet Z Series — Service Manual 3-55
Service Tests (Diagnostics)
12. Set Unit Configuration
This diagnostic test is not available for Z2100/Z3100/Z3100ps/Z3200/
Z3200ps printers.
13. Error 71:19 Recovery
This diagnostic test utility is used to set the Serial Number and Part Number
if either the Formatter or the Printmech PCA or both have been replaced.
The complete Error 71:19 Recovery utility consists of individual utilities to
handle different serial and part number setting requirements. These tests are:
Set Serial Number
Select Right S/N
Set Serial Number
The purpose of this utility is to set the Serial Number and Part Number in
case both the Formatter and the Printmech PCA are replaced at the same
time.
Set the Serial Number as follows:
1 In the Diagnostics menu, scroll to 13. Error 71:19 Recovery and press
OK.
2 The Front Panel will show the 13. Error 71:19 Recovery submenu.
3 In the 13. Error 71:19 Recovery submenu, scroll to Set Serial
Number and press OK to start the test.
This test might not exist for the latest printers with the latest
firmware release.
To Next Page
Loading...