Service Tests and Utilities
3-16 Designjet Z Series — Service Manual
33 The Front Panel shows the test complete display for a few seconds.
34 The Front Panel prompts you to shutdown the printer to complete the test.
35 Press any key to shutdown the printer.
Cutter test
The Cutter is designed to cut roll media after printing for the size of sheet
defined. Before executing this test you should run the Scan Axis, Media Drive
and Carriage tests to ensure that each of these subsystems is operating
correctly.
Perform the Scan Axis - Cutter test as follows:
1 In the Diagnostics menu, scroll to 1. S c a n A xis and press OK.
2 The Front Panel will show the 1. Scan Axis submenu.
3 In the Scan Axis submenu, scroll to Cutter and press OK to start the test.
The Printer will start the Scan Axis subsystem Common Initialization and
Cutter test initialization. If there is a Failure at any point during the tests, the
Front Panel will display the relevant System Error Code. To trouble shoot
any displayed error codes, refer to page
1-7, System Error Codes - Full
Descriptions.
4 The printer then starts the Cutter test to verify the subsystem. As the test
executes the Front Panel displays the following messages:
To Next Page
Loading...