Designjet Z Series — Service Manual 3-43
Service Tests (Diagnostics)
Check Leakage
1 In the Diagnostics menu, scroll to 7. I DS and press OK.
2 The Front Panel will show the 7. IDS submenu.
3 In the IDS submenu, scroll to Check Leakage and press OK to start the
test.
4 The Ink Delivery System test starts and the front Panel prompts you to remove
all the Ink Supplies.
5 The Check Leakage test starts and the Front Panel displays the following
messages:
Starting Horsburgh and Mips
Starting Nvm
Starting Tubes
Reading Tubes status
Getting Part Number
Starting ISS Motors
Starting OOI Sensors
Moving Bongos down
6 While the printer moves the Bongos down, the Front Panel displays the
following message:
To Next Page
Loading...