6-178 Designjet Z Series — Service Manual
Removal and Installation
Encoder Disk and Encoder Sensor
Removal
1. Remove the Left Cover (refer to page 6-30).
2. Remove the Electronics Module (Main PCA
and PSU) (refer to page 6-163).
3. Remove the Left Spittoon (refer to page 6-
175 ) .
4. Remove the Encoder Disk straight off
Media Advance Roller spindle, lift it
straight out of the printer.
5. Disconnect the Encoder Sensor connector.
Switch off the printer and remove the power cable.
The Media Advance Roller
spindle is delicate. Remove the
Encoder Disk gently.
To Next Page
Loading...