6-44 Designjet Z Series — Service Manual
Removal and Installation
Right Rear Tray Support
Removal
1. Remove the Rear Tray (refer to page 6-36).
2. Remove the Right Cover (refer to page 6-
27).
3. Remove the Left Cover (refer to page 6-30).
4. Remove the Rear Cover (refer to page 6-
37).
5. Remove two T-15 screws that secure the
Right Rear Tray Support to the printer.
6. Rotate the Right Rear Tray Support
counterclockwise approximately 30
degrees.
Switch off the printer and remove the power cable.
To Next Page
Loading...