Designjet Z Series — Service Manual 6-75
Removal and Installation - Spindle
Spindle
Removal
1. Pull the left end of the Spindle (viewed from
the front of the printer) out of the Left
Spindle Holder.
2. Lift the Spindle out of the printer towards
the left (viewed from the front of the
printer).
Switch off the printer and remove the power cable.
Rear Tray with tray extensions shown.
It is normal to encounter
Spindles of different diameters
and weights.
Rear Tray with tray extensions shown.
To Next Page
Loading...