6-116 Designjet Z Series — Service Manual
Removal and Installation
Scan-Axis Motor
Removal
1. Remove the Right Cover (refer to page 6-
27).
2. Remove the Left Cover (refer to page 6-30).
3. Loosen the T-10 uncapping screw
sufficiently so you can manually move the
Carriage Assembly in step
4.
4. Push the Carriage Assembly into the print
path.
5. Loosen the T-15 screw Belt Tensioner to the
printer to remove the tension from the belt.
Switch off the printer and remove the power cable.
To Next Page
Loading...