6-100 Designjet Z Series — Service Manual
Removal and Installation
Carriage Assembly and Trailing Cable
Removal
1. Remove the Front Cover (refer to page 6-
17 ) .
2. Remove the Right Cover (refer to page 6-
27).
3. Remove the Left Cover (refer to page 6-30).
4. Remove the Cutter Assembly (refer to page
6-43).
5. Remove the Front Panel (refer to page 6-
48).
6. Remove the Top Cover (refer to page 6-51).
7. Remove the Window Position Sensor (refer
to page 6-54).
8. Remove the Ink Supply Tubes Support Rail
(refer to page 6-56).
9. Loosen the T-10 uncapping screw to
manually uncap the Service Station before
removing the
Encoder Strip (with spring
and attachment nut) (refer to page 6-84).
10. Remove the Encoder Strip (with spring and
attachment nut) (refer to page 6-84).
11 . If necessary manually move the Carriage
Assembly fully right into the docking
station.
12. Use a short torx screwdriver to remove the
two T-10 screws that secure the center
attachment of the Trailing Cables.
Switch off the printer and remove the power cable.
To Next Page
Loading...