HP DesignJet Z2100

Designjet Z Series — Service Manual 6-101
Removal and Installation - Carriage Assembly and Trailing Cable
13. Unclip the center attachment of the Trailing
Cables.
14. Remove the Trailing Cables from the two
double sided adhesive pads that attach it
to the printer.
15. Disconnect the two ribbon cables of the
Trailing Cables from the Electronics
Module.
1
2
Some printers have clips instead
of adhesive pads that attach the
Trailing Cables to the printer. In
this case, unclip the Trailing
Cables from the printer.