Designjet Z Series — Service Manual 3-67
Service Utilities
Scan Motor
Left Spittoon
Right Spittoon
Full Bleed Foams
Aerosol Fans
Carriage
Service Station
3 Once you have selected a Life Counter to reset, the following message will
be displayed on the Front Panel. Press the OK key to reset the selected Life
Counter or press Back/Cancel to exit without resetting the Life Counter.
If the Usage Counter information cannot be read, the Front Panel will display
“Unable to get usage counter”. This could be a possible Firmware error. In
this case, make sure you have the latest version of the Firmware.
4 If the utility exits correctly, OK will be displayed on the Front Panel.
5. Diagnostic Print
The purpose of this Service Utility is to print the Diagnostic Print in order to
identify Print Quality problems. Information regarding the Diagnostic Print is
located in Chapter 1, Troubleshooting. Specifically:
The procedure to make a Diagnostic Print can be found at 1-22, Printing the
Diagnostic Print.
The procedure to make an Advanced Diagnostic Print can be found at 1-29,
Printing the Advanced Diagnostics Print.
Additional print quality information such as troubleshooting and corrective
measures can be found at
1-20, Print Quality Troubleshooting.
To Next Page
Loading...