HP DesignJet Z2100 - Right Starwheel Lifter; Removal

6-208 Designjet Z Series — Service Manual
Removal and Installation
Right Starwheel Lifter
Removal
1. If you are working on a Z3200 series
printer, set the starwheels rail to the HIGH
position using the procedure outlined in the
note above.
2. Remove the Front Cover (refer to page 6-
17 ) .
3. Remove the Right Cover (refer to page 6-
27).
4. Remove the Starwheel Assembly (refer to
page 6-166).
5. Loosen the T-10 uncapping screw
sufficiently so you can manually move the
Carriage Assembly in step
6.
6. Push the Carriage Assembly into the print
path.
Switch off the printer and remove the power cable.
For Z3200 series: To be able to remove this assembly, the starwheels rail
must be at the HIGH position. To reach this position, restart the printer.
During the initialization (near the beginning), the printer will raise the
starwheels rail to the HIGH position. Turn off the printer when the starwheels
rail is at the highest point using the rear button.