Designjet Z Series — Service Manual 3-49
Service Tests (Diagnostics)
8 The Primer Motor test continues and the Front Panel shows the progress of
the test.
9 The Front Panel shows the test complete display for a few seconds.
10 The Front Panel prompts you to shutdown the printer to complete the test.
11 Press any key to shutdown the printer.
Aerosol Fan
1 In the Diagnostics menu, scroll to 8. Service Station and press OK.
Some printers function without an aerosol fan. Before
performing the aerosol fan diagnostic test, remove the
Right Cover to verify that the printer has an aerosol fan
installed (Refer to page 6-27). If the printer does not have
an aerosol fan installed, do not perform this test.
To Next Page
Loading...