HP DesignJet Z2100

Service Tests and Utilities
3-48 Designjet Z Series — Service Manual
 Starting Horsburgh and Mips.
 Starting Nvm.
 Starting TestsGpio.
 Getting Part Number.
 Starting Service Station.
 Starting Scan Axis.
 Moving SVS out of Sax.
 Homing Scan Axis.
 Moving Carriage out of SVS.
 Homing Service Station.
 Starting ServicingServices.
 Capping Service Station.
 Uncapping Service Station.
 Starting Primer Motor
 Starting AcumenSupplies
 Starting FluidManager
 Starting Primer
 Preparing SVS
 Reading Homing Sensor
 Zero Sensor initial value: 0.
 Step 1: current zeroSensor value: 0.
 OK: It has been detected a change in zero sensor.
 Homing Primer Motor
 Starting Mechanical Init.
5 The Front Panel then prompts you to check the status of the printer.
6 Check that:
 The Window is closed.
 The Media Lever is lowered.
 All Printheads are inserted.
 Valid Cartridges are inserted.
7 Press OK to continue.