Designjet Z Series — Service Manual 3-68
Service Utilities
6. Set Date and Time
The purpose of this Service Utility is to set the internal clock of the Printer.
Perform the Set Date and Time utility as follows:
1 In the Service Utilities submenu, scroll to Set Date and Time and press
OK.
2 The Printer will display the current time and the new time. Use the Up and
Down keys to go through the digits and press the OK key to go to the next
digit. You can press the Cancel key at any time to exit the utility without
making any changes.
3 Once the new time has been entered, the Front Panel prompts you to confirm
the new date and time.
4 Press OK to confirm the new date and time. Press BACK to modify the new
date and time. Press CANCEL to exit without changing the date and time.
5 Once the new time has been entered, the Front Panel will prompt you to shut
down the printer.
If the current RTC Clock cannot be set, it could be a possible Firmware error.
Make sure you have the latest version of the Firmware.
6 Restart the printer.
To Next Page
Loading...