Designjet Z Series — Service Manual 6-67
Removal and Installation - Primer Assembly
Primer Assembly
Removal
1. Remove the Right Cover (refer to page 6-
27).
2. Remove the Service Station (refer to page
6-60).
3. Pull out the spitting tube from the Service
Station Spittoon and unroute it from the
attachment clip.
4. Unroute the cable assembly from
attachment clip on the Service Station
Spittoon.
5. Unclip the front left clip that secures the
Service Station to the Service Station
Spittoon.
Switch off the printer and remove the power cable.
To Next Page
Loading...