6-68 Designjet Z Series — Service Manual
Removal and Installation
6. Unclip the front left clip that secures the
Service Station to the Service Station
Spittoon.
7. Carefully raise the Service Station vertically
from the clip side (by approximately 30
degrees) until you can disengage it form
the three attachments on the opposite side
to remove it from the Left Spittoon.
8. Disconnect the three Primer Assembly
tubes.
It is recommended that you
use protective gloves when
handling the Primer Assembly
Use a suitable method to
identify each Primer Assembly
tube for correct re-connection
during assembly components.
To Next Page
Loading...