HP DesignJet Z2100

Designjet Z Series — Service Manual 3-45
Service Tests (Diagnostics)
8. Service Station
The complete Service Station test consists of individual tests for the different
components related to this subsystem.
These tests are:
 Service Station
 Primer Motor
 Aerosol Fan
Diagnostic tests also need to be performed after removing or replacing
certain printer components. If you have removed or replaced printer
components, check the Service Calibration Guide to Removal and
Installation to see which tests and calibrations you need to perform. Refer to
Page 6-8.
Service Station
1 In the Diagnostics menu, scroll to 8. Service Station and press OK.
2 The Front Panel will show the 8. Service Station submenu.
3 In the 8. Service Station submenu, scroll to Service Station and press
OK to start the test.
4 The Service Station test starts and the front Panel displays the following
messages:
 Starting Horsburgh and Mips
 Starting Nvm
 Booting up Carriage.
 Starting SVS Motor.
 Starting Carriage Motor
 Getting Part Number.
 Starting Service Station.
 Starting Scan Axis.
 Moving SVS out of Sax.
 Homing Scan Axis.
 Moving Carriage out of SVS.
 Homing Service Station.