Service Tests and Utilities
3-44 Designjet Z Series — Service Manual
7 If a Bongo remains in the UP position, use your finger to help push it down.
The test continues and displays the following messages:
Reading OOI Sensors
Moving Bongos up
Reading OOI Sensors
Moving Bongos down
8 The front Panel prompts you to insert all the Ink Supplies.
9 Install all the Ink Cartridges.
10 Press OK to continue.
11 The test continues and displays the following messages:
Moving Bongos up
Checking OOI condition
12 The Front Panel then displays Check Leakage test results.
13 The Front Panel shows the test complete display for a few seconds.
14 The Front Panel prompts you to shutdown the printer to complete the test.
15 Press any key to shutdown the printer.
To Next Page
Loading...