Designjet Z Series — Service Manual 6-43
Removal and Installation - Cutter Assembly
Cutter Assembly
Removal
1. Remove the Left Cover Finishing Panel
(refer to step
3 of the Left Cover removal
procedure on page 5-30).
2. Fully loosen the cutter rail end cap
attachment screw.
3. Remove the cutter rail end cap.
4. Slide the Cutter Assembly out of the printer.
Switch off the printer and remove the power cable.
When you install the new Cutter
Assembly, follow the installation
instructions provided with the new
Cutter Assembly.
To Next Page
Loading...