Service Tests and Utilities
3-50 Designjet Z Series — Service Manual
2 The Front Panel will show the 8. Service Station submenu.
3 In the 8. Service Station submenu, scroll to Aerosol Fan and press OK
to start the test.
4 The Aerosol Fan test starts and the front Panel displays the following
messages:
Starting Horsburgh and Mips.
Starting Nvm.
Starting TestsGpio.
Getting Part number.
Reading Aerosol Fan.
5 The front Panel then prompts you switch on the Aerosol Fan.
6 Press OK to switch on the Aerosol Fan. If you do not wish to switch on the
Aerosol Fan use the Arrow keys to select NO and press OK.
7 The test continues and the Front Panel displays the results.
8 Press any key to continue.
9 The front panel prompts you to check if the Aerosol Fan is operating.
10 Listen carefully to check if the Aerosol Fan is operating.
11 If it is operating, use the Arrow keys to select YES and press OK. If it is
NOT operating, select NO and press OK.
To Next Page
Loading...