Service Tests and Utilities
3-54 Designjet Z Series — Service Manual
2 The EEROM Reset test starts and the front Panel prompts you to request if you
want to continue.
3 If you do want to continue the test, use the Arrow keys to select YES and
press OK. If you do NOT want to continue, select NO and press OK.
4 The EEROM Reset test continues and the front Panel displays the following
message:
Starting Horsburgh.
Starting Nvm.
Getting Part Number.
Setting default config.
5 The Front Panel finishes the test and prompts you to Recover the Printheads
after completing the test and rebooting the printer.
6 The Front Panel shows the test complete display for a few seconds.
7 The Front Panel prompts you to shutdown the printer to complete the test.
8 Press any key to shutdown the printer.
9 When the printer restarts, it will purge tubes and perform a printhead
alignment.
To Next Page
Loading...