6-180 Designjet Z Series — Service Manual
Removal and Installation
2. Position the Media Advance Drive
Adjustment Tool on the end Media
Advance Roller shaft, push it firmly onto the
shaft and maintain a constant pressure to
ensure it is flush to the Media Advance
Drive.
3. While still maintaining pressure on the
Media Advance Drive Adjustment Tool,
fully tighten the Encoder Sensor position
adjustment screw.
4. Remove the Media Advance Drive
Adjustment Tool.
5. Complete the installation of the Encoder
Sensor and a new Encoder Disk.
This step is important. If not
done correctly, the printer may
not function correctly.
To Next Page
Loading...