6-150 Designjet Z Series — Service Manual
Removal and Installation
11 . Carefully lift the Cartridge Tubes Connector
out of the Left Ink Supply Station.
12. Carefully lift the Left Ink Supply Station
enough so that you can rotate it
counterclockwise to release the front
attachment from the printer.
13. Carefully lift the Left Ink Supply Station
completely out of the printer.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
Refer to page 6-8,
Service Calibration Guide to Removal and Installation
.
To Next Page
Loading...