6-206 Designjet Z Series — Service Manual
Removal and Installation
8. Rotate the Left Starwheel Lifter sufficiently to
disengage the right attachment lug.
9. Tilt the Left Starwheel Lifter sufficiently to
disengage the left attachment lug.
10. Remove the Left Starwheel Lifter from the
printer.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
Refer to page 6-8,
Service Calibration Guide to Removal and Installation
.
To Next Page
Loading...