Juniper T640 - Chapter 15 Unpacking the T640; Tools and Parts Required to Unpack the T640 Router; Unpacking the T640 Router

CHAPTER 15
Unpacking the T640
•
Tools and Parts Required to Unpack the T640 Router on page 153
•
Unpacking the T640 Router on page 153
•
Verifying the T640 Router Parts Received on page 155
Tools and Parts Required to Unpack the T640 Router
To unpack the router and prepare for installation, you need the following tools:
•
Phillips (+) screwdriver, number 2
•
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
•
Blank panels to cover any slots not occupied by a component
Related
Documentation
T640 Chassis Description on page 15•
• T640 Router Description on page 3
Unpacking the T640 Router
The router is shipped in a wooden crate. A wooden pallet forms the base of the crate.
The router chassis is bolted to this pallet. Quick Start installation instructions and a
cardboard accessory box are also included in the shipping crate.
The shipping crate measures 50 in. (127 cm) high, 30 in. (76.2 cm) wide, and 41 in. (104 cm)
deep. The total weight of the crate containing the router and accessories can range from
582 lb (267 kg) to 650 lb (295 kg).
NOTE: The router is maximally protected inside the shipping crate. Do not
unpack it until you are ready to begin installation.
To unpack:
153Copyright © 2017, Juniper Networks, Inc.