CHAPTER 23
Configuring the Junos OS Software
•
Preparing to Configure the T640 Router on page 251
•
Initially Configuring the T640 Router on page 251
•
Configuring DC Power on a T640 Router on page 255
Preparing to Configure the T640 Router
Gather the following information before configuring the router:
•
Name the router will use on the network
•
Domain name the router will use
•
IP address and prefix length information for the Ethernet interface
•
IP address of a default router
•
IP address of a DNS server
•
Password for the root user
Related
Documentation
Initially Configuring the T640 Router on page 251•
Initially Configuring the T640 Router
The T640 Core Router is shipped with the Junos OS preinstalled and ready to be
configured when the T640 router is powered on. These procedures connect a router to
the network but do not enable it to forward traffic. For complete information about
enabling the router to forward traffic, including examples, see the Junos OS configuration
guides.
You configure the router by issuing Junos OS command-line interface (CLI) commands,
either on a console device attached to the CONSOLE port on the CIP, or over a telnet
connection to a network connected to the ETHERNET port on the CIP.
251Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
